6/11/2023 0 Comments Geometers sketchpad activitiesYou will need to translate the point vertically (90 degrees) by the Marked Distance: ![]() Select the moving point on the segment and choose Translate under the Transformmenu.Select the length measurement and choose Mark Distance under the Transformmenu.You will now start to construct the other sides of the square. (Check to make sure that you measured the right length by sliding the interior point back and forth on the segment. Select this new segment only and measure its length by choosing Length under the Measure menu:.Construct another segment between the left hand end point of the original segment and the new point.Select the segment and choose Point On Object under the Constructmenu to construct a point on the segment.Ensure that they are both selected and choose Segment under the Construct menu to construct the segment between them. ![]() Use the point tool to construct two points. In this activity, you will use Geometer's Sketchpad to produce the basic sketch that is required for this demonstration.
0 Comments
Leave a Reply. |